Nortel Passport 7400, Установка оборудования, техническое обслуживание и устранение неисправностей, Страница: 420 / 438

420 Chapter 37 Hardware procedures
241-7401-240 5.2S1
Unpacking a 16-slot Passport switch
Unpack a 16-slot Passport switch close to the installation site.
Prerequisites
Procedure steps
1 Use a knife to open the packaging.
2 Place the control and function processor boxes (labeled with their names
and Nortel Networks part numbers) and termination panel boxes to one
side. You can unpack them later.
3 Take each remaining unit of equipment from its box, and carefully remove
its protective packaging.
4 Inspect the equipment for damage. If any equipment is damaged, contact
your purchasing department and arrange to have it replaced.
5 Clear the unpacking area of all debris. Keep all the packing material and
containers in case the equipment has to be moved later.
6 Compare the contents of your shipment with the table “Equipment
checklist for unpacking a 16-slot Passport switch” (page 421) and the
figure “Taking inventory after unpacking a 16-slot Passport switch”
(page 422) to ensure you have all the hardware you require.
If you purchased a
16-slot Passport switch
separately (not as part of
a cabinet package) Nortel packages each unit of hardware
separately, including the switch shelving.
CAUTION
Avoid structural stress when maneuvering uncrated
shelf assemblies
When handling and moving uncrated shelf assemblies,
avoid strain, excessive shock or vibrations that can
damage or warp the equipment.
CAUTION
Risk of electrostatic damage
When handling circuit cards, wear a grounded antistatic
wrist strap or equivalent protection to avoid damaging
electronic parts.