Nortel Passport 7400, Установка оборудования, техническое обслуживание и устранение неисправностей, Страница: 233 / 438

Chapter 37 Hardware procedures 233
Passport 7400 Hardware Installation, Maintenance, and Upgrade 5.2S1
4 Close the latches to seat the processor card connectors in the backplane
connectors and apply some additional pressure to the faceplate to ensure
the processor card is fully inserted in the shelf.
5 Lock the latches as shown the figure “Locking and unlocking processor
card latches” (page 239).
6 If synchronization does not automatically begin, manually synchronize the
inserted CP with the active CP. See the section on disk synchronization in
241-5701-600
Passport 7400, 15000, 20000 Configuration Guide.
7 Monitor the status of the processor card by observing the status LED as
it lights throughout the initialization sequence. It can take several minutes
for a new control processor to be synchronized. See “Processor card LED
status display” (page 241).
8 Connect any CP cables as necessary. See “Connecting a local operator
terminal to a Passport 7400 switch” (page 186); “Installing an Ethernet
cable” (page 259); or “Installing CP cables for BITS” (page 265).