Nortel 4050, Руководство пользователя

Страница: 468 / 922

468 Chapter 10 Configuring system settings
320818-A
reboot
Reboots the Nortel SNAS 4050.
If the Nortel SNAS 4050 you want to reboot has
become isolated from the cluster, you will receive an
error message when executing the
reboot command.
In this case, log on to the Nortel SNAS 4050 using a
console connection or remotely by connecting to the
Nortel SNAS 4050 RIP (host address). Then use the
/boot/reboot command (see page 734 ).
delete
Removes the Nortel SNAS 4050 host from the cluster
and resets the device to its factory default
configuration. Other Nortel SNAS 4050 devices in the
cluster are not affected.
To ensure that you remove the intended Nortel
SNAS 4050, first use the
/cfg/sys/host #/cur
command to view current settings and verify that it is
the correct host. (To view information for all Nortel
SNAS 4050 devices in the cluster, use the
/cfg/sys/cur
command.)
After you have removed the Nortel SNAS 4050 from
the cluster, you must use a console connection to
access the device. Log on as the
admin
user with the
admin
password to enter the Setup utility.
Note: If there are other Nortel SNAS 4050 devices in
the cluster configuration, you cannot delete a device if it
is the only Nortel SNAS 4050 in the cluster whose
status is up. In this case, you will receive an error
message when executing the
delete command. To
delete a device from the cluster while all the other
cluster members are down, log on to the Nortel
SNAS 4050 using a console connection or remotely by
connecting to the Nortel SNAS 4050 RIP (host
address). Then use the
/boot/delete command.
When the remaining cluster members come back up,
connect to the MIP and repeat the command to delete
the Nortel SNAS 4050 from the cluster configuration
(
/cfg/sys/host #/delete ).
/cfg/sys/host < host ID >
followed by: