69
| 11.2019
Transport
Rocker circular saw 46-217 and 46-218
Do not make any sudden movements.
The notches on the rocker prevent the wood piece from turning
during the cutting process.
After cutting, the rocker moves back again into its starting position.
In the event the spring breaks, the rocker does not move back
again into its starting position. In this event, you must use a
new spring (see “Replacing the return spring” on page 74).
›
After the first cutting process has been fully completed, insert the
next wood piece.
›
Remove the sawed wood on the right-hand side of the rocker.
›
Switch the rocker circular saw off after use.
Transport
›
Before changing location, always disconnect the mains plug.
›
Loosen the chain with locking pins from the support and axle.
›
Push the rocker towards the saw blade.
›
Rotate the support until the safety hook locks in place.
›
Hold the transport handle with both hands.
›
Push down on the axle with a foot and tilt the rocker circular saw
forwards slightly.
It is now possible to roll the rocker circular saw.
›
To put down, push down on the axle again with a foot and put the
saw down carefully.
i
i
Fig. 13:
Safety hook in
the transport position
EN