76
| 11.2019
Decommissioning and disposal
Rocker circular saw 46-217 and 46-218
Decommissioning and disposal
If the rocker circular saw is no longer usable and must be scrapped,
decommission and disassemble it. You must bring the rocker circular
saw into a condition whereby it can no longer be used for the purposes
for which it was designed.
›
During the scrapping process, note that the basic materials of the
rocker circular saw may be reused in the recycling process.
The manufacturing company rejects all responsibility for any
personal injury or material damage that is caused by the reuse
of machine parts, where these are used for any purpose other
than the original material purpose.
Proceed as follows to decommission the rocker circular saw:
›
Block all moving machine parts.
›
Disassemble all electrical components and dispose of these
separately to the machine at controlled disposal points.
›
Dismantle the machine into its individual parts and submit all
components to controlled disposal points.
After decommissioning and blocking the moving parts, no further
residual risk exists.
When disposing of the rocker circular saw or its components:
›
Observe the nationally applicable regulations and directives.
Storage
›
Remove the power plug.
›
Only store the rocker circular saw in enclosed rooms.
›
Ensure that the storage room is well ventilated and dry.
Before storing the rocker circular saw for a long period of time,
clean it thoroughly (see “Cleaning the rocker circular saw” on
page 71).
i
i