Nitto DURA SI600, Инструкция по эксплуатации

Страница: 126 / 175

SETUP PROCEDURE
3-78
3.8 Operations under Sensor Check Mode
Checking of operations as for whether the sensor is properly functioning or not can be done.
After moving to sensor check mode, turn the dial to select a setting menu.
Setting menu and the corresponding contents are shown below.
Setting Menu Content
Reference
Page
1 GAP1 SENSOR Feed 1 page of label and check the operation to see whether GAP1 Sensor can detect
the label. P.3-79
2 GAP2 SENSOR Feed 1 page of label and check the operation to see whether GAP2 Sensor can detect
the label. P.3-79
3 I-MARK1 SENSOR Feed 1 page of label and check the operation to see whether I-Mark1 Sensor can
detect the label. P.3-79
4 I-MARK2 SENSOR Feed 1 page of label and check the operation to see whether I-Mark2 Sensor can
detect the label. P.3-79
5 HEAD UP SENSOR Operate the head and check the operation to see whether head up sensor is properly
functioning. P.3-80
6 ROLLER SENSOR Operate the feed roller and check the operation to see whether feed roller sensor is
properly functioning. P.3-81
7 RIBBON SENSOR Turn the new ribbon holder and check the operation to see whether ribbon sensor is
properly functioning. P.3-82
8 DUMPER SENSOR Please lower the dumper arm first, and check the operation to see whether the dumper
sensor is properly functioning. P.3-83
9 HEAD
TEMPERATURE
Check whether the temperature of thermal head is correctly displayed. P.3-84
10 PRINTER
TEMPERATURE
Check whether the temperature inside the printer is correctly displayed. P.3-84
11 DISPENSER SENSOR Insert label in between the light emitting and light sensing devices of dispenser
sensor and check the operation to see whether the label can be detected.
* The option can be displayed/set only when the print configuration of selecting
“DISPENSER” for the setting menu “1-1 Printing Mode” under Label Set mode
is applied.
P.3-85
12 EXTERNAL SIGNAL
INPUT CHECK
Check data communication to see whether input signal from external equipment
connected to the input terminal can be properly received. P.3-86
13 EXTERNAL SIGNAL
OUTPUT CHECK
Check the communication to see whether output signal for external equipment
connected to the output terminal can be properly sent. P.3-87
14 End Tape Insert the thermal transfer ribbon in between the light emitting and light sensing
devices of end tape sensor and check the operation to see whether the thermal
transfer ribbon can be detected. P.3-88