Nitto DURA SI600, Инструкция по эксплуатации

Страница: 74 / 175

SETUP PROCEDURE
3-26

Auto Adjustment of Pitch Sensor
1
Display “AUTO”.
2
Press the key.
Instruction message will be displayed.
3
Open the side cover.
4
Lay the backing paper of label on the top of sensor, and press the
key.
Peel off the label and turn to use backing paper only.
Please lift both the head and the presser towards free direction and lay the backing paper of label in
between the light emitting and light sensing devices. If label without backing paper is used, please
lay the plain part of label in pitch sensor.
Measuring is started.
If the measuring process is being done, the message of “MEASURING” will be displayed.
When measuring finishes, result of adjustment will be displayed.
5
Confirm the result of adjustment and press the
key.
Confirm the content of adjustment and return to selection of adjustment options.
Please remember to lock the head and the presser, and then close the side cover.
Press the key
and return to selection of
adjustment options.
Press the key
and return to selection
of adjustment options
without confirming the
result of adjustment.
When opening the
side cover, please
open it completely
untill the top surface of
the cover touches the
printer main part. If you
release your hands
when the cover is half
open or in the midway
of opening/closing it,
the cover might fall
and result in injury
and/or malfunction.
When handling the
Head Lock Lever,
please do not put
your fingers and/or
hands near the tuning
area of thermal head.
It might cause injury.
Please confirm that
after the Presser is
released it is well
fastened with the
Magnet.
If you release your
hands in the midway
of opening /closing,
the Presser might fall
and result in injury.