Monteris Medical Neuroblate, Инструкция по эксплуатации

Страница: 55 / 158

NeuroBlate® System Instructions for Use
80469 Rev D – Nov 16, 2018
- 55 -
7.5.7. Thermal Monitoring Slice Planes
Figure 7.5.71: Main User Interface Layout
The NeuroBlate System M*Vision Software monitors three, 5 mm thick slice planes
simultaneously during thermal delivery (see Figure 7.5.71). Each slice plane is separated by a
0.25mm slice gap. There are 13 slice plane locations available for thermal imaging along the set
trajectory which are numbered Distal 2 (D2), Distal 1 (D1), 1 through 9, Proximal 1 (P1),
Proximal 2 (P2). The center of each slice plane is described by the parallel white dotted lines
above. The position of the slice planes are determined when the user sets the Probe Deepest
Penetration (PDP) during trajectory planning. The PDP point is identified by the center of the
orange circle at the tip of the LDP when the probe position is at 0 mm.
The three active thermal monitoring planes to be displayed during thermal delivery are
described by solid red lines superimposed over the dotted lines. The default position for the
middle (second) slice of the three active monitoring planes is centered directly over the laser
exit position of a SideFire (SFP) which is ~3mm superior to the distal tip of the SFP. The software
rendered LDP can be manipulated in the linear direction to rest between the outer two thermal
slice planes based on the user’s preference for slice positioning with respect to the laser exit for
the SideFire.
Figure 7.5.72: SFP Thermal Monitoring Setup
PDP
Software
Rendered
LDP
Laser Exit
location (x)
SF Probe
SF Probe
Three Active
Monitoring
Planes