Mitsubishi Electric MELSERVO MR-J2 C Series, Инструкция по эксплуатации

Страница: 255 / 265

14 - 28
14. OPTIONS AND AUXILIARY EQUIPMENT
(b) Surge suppressor
The recommended surge suppressor for installation to an AC relay, AC valve, AC electromagnetic
brake or the like near the servo amplifier is shown below. Use this product or equivalent.
MS
Surge suppressor
Relay
This distance should be short
(within 20cm(0.79 in.)).
Surge suppressor
Surge suppressor
(Ex.) 972A.2003 50411
(Matsuo Electric Co.,Ltd.-200VAC rating)
Outline Drawing [Unit: mm] ([Unit: in.])
Rated
Voltage
AC[V]
C [ F] R [ ] Test Voltage AC[V]
200 0.5
50
(1W)
Across
T-C 1000(1 to 5s)
Blue vinyl cord
Red vinyl cord
Vinyl sheath
10 3
(0.39
0.12)
200(7.87)
or more
200(7.87)
or more
10 3
(0.39
0.15)
18 1.5
(0.71 0.06)
15 1(0.59 0.04)
48 1.5
(1.89 0.06)
6(0.24)
4(0.16)
31(1.22)
10(0.39)or less 10(0.39)or less
Note that a diode should be installed to a DC relay, DC valve
or the like.
Maximum voltage: Not less than 4 times the drive voltage
of the relay or the like
Maximum current: Not less than twice the drive current of
the relay or the like
RA
Diode
+ -
(c) Cable clamp fitting (AERSBAN- SET)
Generally, the earth of the shielded cable may only be connected to the connector's SD terminal.
However, the effect can be increased by directly connecting the cable to an earth plate as shown
below.
Install the earth plate near the servo amplifier for the encoder cable. Peel part of the cable sheath
to expose the external conductor, and press that part against the earth plate with the cable clamp.
If the cable is thin, clamp several cables in a bunch.
The clamp comes as a set with the earth plate.
Srip the cable sheath of
athe clamped area.
cutter
cable
Cable clamp
(A,B)
Cable
Earth plate
External conductor
Clamp section diagram
40
(1
.5
7)
[Unit: mm(in)]
Downloaded from ManualsNet.com search engine