Mitsubishi Electric MELSERVO MR-J2 C Series, Инструкция по эксплуатации

Страница: 240 / 265

14 - 13
14. OPTIONS AND AUXILIARY EQUIPMENT
14.1.3 Junction terminal block (MR-TB20)
POINT
When using the junction terminal block, you cannot use SG of CN1A-20
and CN1B-20. Use SG of CN1A-4 and CN1B-4.
(1) How to use the junction terminal block
Always use the junction terminal block (MR-TB20) with the junction terminal block cable (MR-
J2TBL M) as a set. A connection example is shown below:
Servo amplifier
Junction terminal block
MR-TB20
CN1A
or
CN1B
Cable clamp
(AERSBAN-ESET)
Junction terminal
block cable
(MR-J2TBL05M)
Ground the junction terminal block cable on the junction terminal block side with the standard
accessory cable clamp fitting (AERSBAN-ESET). For the use of the cable clamp fitting, refer to Section
14.2.6, (2)(c).
(2) Terminal labels
The junction terminal block is supplied with terminal block labels which indicate signal assignment.
Among these labels, use the two for MR-J2-C. When changing the input signals on the Servo
Configuration Software, refer to Section 14.1.2 (3) and Section 3.2.2 and apply the accessory signal
seals to the labels.
0 1 2 3 4 5 6 7 8 9
10
11
12 13 14 15 16 17 18 19
1) For CN1A
0 1 2 3 4 5 6 7 8 9
10
11
12 13 14 15 16 17 18 19
2) For CN1B
PP LG OPC COM PG
P15R NP NG SG DOG SD ZP CPO VC INP SG ST1 TLA
VDD LG DIO ST2 MDO P15R
DI1 LSP
COM SON
ALM SD
LSN RD
(3) Outline drawing
[Unit: mm]
([Unit: in.])
60
(2
.3
6)
7
50
(1
.9
7)
117(4.61)
126(4.96)
(0
.2
8)
MITSUBISHI
MR-TB20
46.
2
(1
.82)
Terminal screw: M3.5
Applicable cable: Max. 2mm
(Crimping terminal width: 7.2mm (0.283 in) max.)
2
2- 4.5(0.18)
Downloaded from ManualsNet.com search engine