Mitsubishi Electric M70V Series, Руководство по подключению

Страница: 75 / 250

2 General Specifications
MITSUBISHI CNC
50
(3) Machine output (DO-L)
(4) Machine output (DO-R)
The digital signal output circuit uses a sink type (DX1x0) or source type (DX1x1).
Use within the specification ranges shown below.
Output circuit
Output conditions
(Note 1) When using an inductive load such as a relay, always connect a diode (voltage resistance 100V or more,
100mA or more) in parallel to the load.
(Note 2) When using a capacitive load such as a lamp, always connect a protective resistor (R=150
Ω
) serially to
the load to suppress rush currents. (Make sure that the current is less than the above tolerable current
including the momentary current.)
Insulation method
Non-insulation
Rated load voltage
24VDC
Max. output current
60mA/point
Output delay time
40
μ
s
R
RA
DO-L/DO-R
PL
R
DO-L/DO-R
RA
PL
Sink type (DX1x0)
Source type (DX1x1)
24VDC(+)
Control
circuit
(Machine side)
Control
circuit
(Machine side)
24VDC(+)