Mitsubishi Electric FR-D720-0.2K-G, Инструкция по эксплуатации

Страница: 43 / 302

32
Connection of stand-alone option unit
2.4.4 Connection of the power regeneration common converter (FR-CV)
When connecting the power regeneration common converter (FR-CV), connect the drive unit terminals (P/+ and N/-) and
power regeneration common converter (FR-CV) terminals as shown below so that their symbols match with each other.

Keep input terminals (R/L1, S/L2, T/L3) open. Incorrect connection will damage the drive unit.

Do not insert an MCCB between the terminals P/+ and N/- (between P/L+ and P/+, between N/L- and N/-). Opposite polarity of terminals
N/- and P/+ will damage the drive unit.

Always connect the power supply and terminals R/L11, S/L21, T/MC1.
Operating the drive unit without connecting them will damage the power regeneration common converter.

Use Pr. 178 to Pr. 182 (input terminal function selection) to assign the terminals used for the X10, RES signal. (Refer to page 117.)

Be sure to connect terminal RDYB of the FR-CV to the X10 signal or MRS signal assigned terminal of the drive unit, and connect terminal
SE of the FR-CV to terminal SD of the drive unit. Without proper connecting, FR-CV will be damaged.
NOTE
 The voltage phases of terminals R/L11, S/L21, T/MC1 and terminals R2/L1, S2/L2, T2/L3 must be matched.
 Use sink logic (factory setting) when the FR-CV is connected. The FR-CV cannot be connected when source logic is
selected.
 Do not connect a DC reactor (FR-HEL) to the drive unit when FR-CV is connected.
 A Filterpack (FR-BFP2) cannot be connected when FR-CV is connected.
Parameters referred to
Pr. 30 Regenerative function selection Refer to page 114.
R/L
11
Dedicated stand-alone
reactor (FR-CVL)
S/L
21
T/L
31
R2/L
12
S2/L
22
T2/L
32
R2/L
1
S2/L
2
T2/L
3
R/L
11
S/L 21
T/MC1
P/L+
U
V
W
M
FR-CV type power
regeneration common converter
Drive unit
PC
SD
X10
RES
SD
P24
SD
RDYB
RSO
SE
RDYA
N/L-
*4
*5
*2
*4
*3
R/L1
S/L2
T/L3
P/+
N/-
*1
Three-phase
AC power supply
MCCB
MC
1