MIMAKI CG-60SR, Руководство по эксплуатации

Страница: 59 / 144

Perform Multiple Cuttings
3-11
3
Use
ful Func
tion
• If the multiple sheet cutting is executed immediately after cutting in the remote mode, cutting
(plotting) will be overlapped. To avoid this trouble, be sure to set the new origin.
• While the plotter is executing the multiple sheet cutting, it ignores data sent from the computer.
• To send two or more pieces of data from the computer to the plotter, the data has to be sent
while providing an interval of 10 seconds or more between any two pieces of data. If two
pieces of data are sent from the computer to the plotter within 10 seconds, the two pieces of
data will be subjected to the multiple sheet cutting.
• During setting of the two-point axis alignment, if the origin updated inside the plotter fails to fall
within the available cutting area, the plotter will not perform cutting for the data.
• The plotter performs cutting for divided cutting data by the specified number of sheets without
dividing the data. If any error is displayed, refer to [Chapter 4] .