MIMAKI CG-60SR, Руководство по эксплуатации

Страница: 121 / 144

Before taking a phenomenon as a trouble
4-3
4
In Case of T
rouble
Phenomenon Cause Remedy
Slippage of sheet arises in
cutting.
The sheet was bent and came
off the backing paper and thus
there are air bubbles between
them.
When a long leaf sheet is to be
cut, take care not to bend the
sheet while feeding or cutting it
and do not put any extra load on
the sheet.
When a long leaf sheet is to be
cut, provide a sufficient space for
working in the direction of sheet
feeding.
Front: 1.5 m or more
Rear: 1.5 m or more
The setting direction (Front /
Rear) of the sheet and the
direction specified on the data do
not agree with each other.
Correct the sheet setting or data
setting.
The sheet comes in contact with
the floor surface. (The front end
of the sheet is cut aslant.)
Decrease the cutting speed
(SPEED) to reduce the load on
the sheet when it comes in
contact with the floor surface.
The side margins of the sheet
beside the pinch rollers are not
enough. Provide a side margin of 20 mm
or more on each side of the
sheet beside the pinch rollers.
The tool is dragged during
operation.
An unexpected imprint of the
cutter remains on the sheet.
The sheet is warped.
Load the sheet on the plotter so
that the sheet is not warped.
The sheet is warped.
Turn the power off and try to lift/
lower the tool holder by hand.
If the tool holder does not move
up but remains in the lower
position, contact your distributor.
An extremely thick sheet is used.
Use a sheet meeting the
specification.
Some parts remain uncut.
Low pressure on the cutter
blade.
• Increase the setting value of
[ADJPRS OFS].
• Raise the cutter pressure, and
check the result -> Test plotting
“SQUARE CUT”