MIMAKI CG-60SR, Руководство по эксплуатации

Страница: 124 / 144

4-6
Error message Cause Remedy
ERR37 MARK ORG
The origin point was detected outside
the cutting area. Arrange the registration marks inside
the sheet.
ERR38 MARK SCALE
Registration mark detection was not
achieved. However, this error is
attributable to a false detection or a
compensation value setting error,
since the calculated compensation
value is wrong.
Correct the compensation value if it is
wrong, and perform detection again.
The required scale compensation
value was not smaller than 1.3 times
or not greater than 0.7 times.
Remove the cause of the detection
error, for example, correct the blurred
print of registration mark data and then
retry.
A detection error occurred since the
distance from the adjacent graphics
was too short. Increase the distance from the
adjacent graphics properly, and
perform printing again.
The designateed spacing between
the registration marks is not correct.
The value of the spacing between the
registration marks designated by the
command is wrong and it is attributable
to a selection error of data. Therefore,
check the output data.
The print is not uniform and some
graphics are omitted.
Correct the graphic data to obtain
uniform print and perform printing
again.
As the printed registration mark was
blurred, it was not read correctly and
the registration mark of the next
graphics was read by mistake.
Perform printing again with care that
the print is not blurred.
ERR40 MOTOR A
An excessive load was applied to the
sheet feeding motor.
Turn the power off once and turn it on
again.
Change the sheet setting to [HEAVY].
(
P.3-66
)
When a roll sheet is used, perform
sheet feeding to draw it out by a
needed length beforehand.
If the same error message still
appears, contact your distributor or a
sales office of MIMAKI.
ERR41 MOTOR B
An excessive load was applied to the
carriage driving motor.
ERR42 A CURRENT
An overcurrent error in the motor in
the sheet feeding direction was
detected.
ERR43 B CURRENT
An overcurrent error in the motor in
the sheet width direction was
detected.
ERR50 ORIGIN
The plotter has failed to detect the
sheet size.
Turn the power off once and turn it on
again.
If the same error message still
appears, contact your distributor or a
sales office of MIMAKI.
ERR51 PINCH POS*
The pinch rollers are not on the grit
rollers. Move the pinch rollers onto the grit roll-
ers.