MIMAKI CG-60SR, Руководство по эксплуатации

Страница: 44 / 144

2-20
Test cutting (plotting)
Execute test cutting (plotting) to confirm the tool conditions.
In the test cutting, the plotter cuts two squares.
1
Confirm that the plotter is in the local
mode.
2
Press the key a few times to
select [SQUARE CUT].
3
Press the key .
• The plotter will execute test cutting (plotting) and then return to the local mode display.
Change the settings of the cut conditions according to the test cutting (plotting) results.
• When the cutter blade is worn and dull, you can use it temporarily by enhancing the value of
PRESSURE. However, you are recommended to replace the worn cutter blade with a new one
to ensure a satisfactory cutting quality.
• When the tool conditions are proper, the results of test cutting (plotting) are as follows:
The two squares are cut perfectly.
The base sheet remains uncut.
No corner of the squares is round.
No corner of the squares is curled-up.
Cut Condition Cause Remedy
Some parts uncut.
The blade floats above the sheet
because of a too high cutting
speed. Lower the speed.
Tighten up the thumbscrew for the tool holder.
The base sheet has
been cut.
Too high pressure. Lower the pressure.
Too large protrusion of the cutter
blade.
Adjust the protrusion of the cutter blade.
Any of the square
corners rounded.
Improper OFFSET value.
Adjust the OFFSET value so that it suits the
cutter blade in use.
Any of the square
corners curled-up.
The protruding amount of the
cutter edge is too much.
The cutting pressure is higher.
The [COMPENSATION
PRESSURE OFFSET value] is
greater.
More than two out of the above
fall under this category. Adjust the protrusion of the cutter blade.
Adjust the cut pressure
Adjust the ADJ-PRS OFS value
C U T 1 2 0 0 5 0 0 . 3 0
S Q U A R E C U T < E N T >
FUNCTION
ENTER/HOLD