MIMAKI CG-60SR, Руководство по эксплуатации

Страница: 55 / 144

3-7
Set the distance compensation
3
Use
ful Func
tion
Setting procedure
1
Press the key in the local mode.
• Tool conditions are displayed with the cursor
blinking at the [SPEED] value.
2
Press the jog key .
• The cursor blinks at the tool number.
• Press the jog key
or to change the tool number.
3
Press the jog key .
• Press the jug key to return to select the tool
number.
4
Press the key .
• The display shows each of the current
compensation values for about one second first. Then the display shows the reference
length (mm) that was subjected to the previous compensation.
• If no distance compensation has been performed, the minimum reference length will be
displayed.
• The display will be as shown at right if the selected unit of
length [MM/INCH] is different from that selected at the
previous compensation.
。
5
Change the reference lengths in the A direction (back and forth
direction) with the jog key
or .
• The reference length in the A direction turns out to be the reference length for both of AR
(back and forth direction in the right side) and AL (back and forth direction in the left side).
• If you change the reference lengths in the A direction, the distance compensation values
(AR, AL) will be cleared.
6
Press the key to determine
the reference length in the A direction.
• You can determine it also with the jog key .
• Move to set the reference length in the B direction.
C U T 1 2 0 0 5 0 0 . 3 0
TOOL
C U T 1 2 0 0 5 0 0 . 3 0
D I S T . C O M P . < E N T >
A = 5 0 0 B = 2 0 0
ENTER/HOLD
A = - - - - B = - - - -
A = 1 0 0 0 B = 2 0 0
ENTER/HOLD