MIMAKI CG-60SR, Руководство по эксплуатации

Страница: 125 / 144

4-7
Troubles for which error messages are given on the LCD
4
In Case of T
rouble
Status message
The messages given below appear in the remote mode.
They do not indicate errors but require an appropriate action.
Message Cause Remedy
CUT1 * REMOTE * The plotter is in the remote mode.
A press on the key will cause
the plotter to enter the local mode.
CUT1 * 128KB *
This indicates the amount of data
received.
Once cutting (plotting) is started, the
amount of data will decrease in steps
of 1 KB.
** OFFSCALE **
The cutting data exceeds the effective
cutting area.
Or the plotter has stopped after cutting
the sheet up to its end normally.
Use a larger sheet, decrease the
amount of data or execute the divided
cutting function.
** NO SHEET **
No sheet has been set or a transparent
sheet has been set. Load a sheet or turn off the sheet
sensor.
** VIEW **
The plotter has received the not-ready-
mode (NR;) signal from the host
computer and has entered the local
mode.
Execute the required operations, such
as the sheet detection or the
establishment of an origin. Then, press
the
key to make the plotter to
enter the remote mode.
** DIGITIZE **
The plotter has received the digitization
command (DP;) from the host
computer and has entered the
digitization mode.
Move the pen to a desired location,
where necessary, and press the
key.
To reset the digitization mode, execute
the data clear using the
key.
** END COPY **
The plotter has terminated copying
after completion of one sheet copying,
since the data received contains the
origin updating command (ZT;, !PG;).
The plural sheets cutting function is
disabled. To perform plural sheets
cutting, change the setting back to
enable the function on the host
computer.
* DIVISION * 5s
The plotter has finished the cutting
corresponding to a division of the data
that exceeds the sheet width, using the
division cut function, and is now
waiting for the receipt of the next data.
If the plotter does not receive any data
from the host computer within ten
seconds, it will recognize the data has
ended.
Then, the plotter will perform the frame
cutting and mark cutting and enter the
local mode.
* END DIVISION *
This message appears in any of the
following cases:
• The plotter has received data that
contains the origin updating
command (ZT;, !PG;).
• The sheet width is 1 cm or less.
• The sample cutting data exceeds the
sheet width.
• The two-point axis alignment is set to
ON.
• Registration marks have already
detected.
Division cut is disabled.
REMOTE
REMOTE
REMOTE
FUNCTION