MIMAKI CG-60SR, Руководство по эксплуатации

Страница: 123 / 144

4-5
Troubles for which error messages are given on the LCD
4
In Case of T
rouble
Error message Cause Remedy
ERR36 MARKdetect
(Show this message
itself)
No registration mark was detected.
(Right after the sheet detection)
Check the sheet for curling.
Check to see if the starting point to
detect the registration mark has been
set properly. (
P.3-24
)
Check to see if the black registration
mark is printed against the white
background.
Check to see if there is no dust or dirt
between the registration marks.
Check to see if there is no mistake in
registration mark settings.
(
P.3-18 )
Confirm the status and the settings
described above. If still no registration
mark is detected, contact your
distributor or a sales office of MIMAKI.
ERR36 MARKdetect
and
“JOG & ENT or END”
are displayed
alternately.
“ERR38
MARKSCALE”
and
“JOG & ENT or END”
are displayed
alternately.
No registration mark was detected.
(During copy-cutting operation)
(
P.3-21)
Check to see if there is no print or dirt
between the registration marks.
Check to see if the black registration
mark is printed against the white
background.
Check to see if there is no mistake in
registration mark settings.
(
P.3-18 )
When using a non elastic sheet, the
registration mark to be used should be
8 mm or more on a side. Separate the
copied registration marks from each
other by 8 mm or more.
In case error occurs, the Light Pointer
stops at the detection starting point. If
the position is found improper, move
the Light Pointer to the appropriate
position using jog keys.
Press the
key to make the
plotter perform detection again.
In case no registration mark is
detected even by retrying the detection
several times, contact your distributor
or a sales officeof MIMAKI.
ENTER/HOLD
Starting point of the registration
mark detection for copy in the
lateral direction.
Starting point of the registration
mark detection for copy in the
vertical direction.