MIMAKI CG-60SR, Руководство по эксплуатации

Страница: 126 / 144

Troubles for which error messages are given on the LCD
4-8
Message Cause Remedy
COPY SKIP
A mark cannot be detected during
continuous copying. One pattern is
skipped.
There is no problem if the marks are
successfully detected after skipping
one pattern. If marks cannot be
detected continuously by five patterns
or more, [ERR36 MARKdetect]
(
P.4-5
) is displayed.
MEDIA SKEW
<ENT>
The deviation of the sheet exceeded
the setting value of the SKEW CHECK
(
P.3-22
)
Press the key after
resetting the sheet.
PAUSE REMOTE/
END
The plotter is holding the mark detect
operation, since
has pressed
while detecting a mark.
Press key to resume the
mark detection, or press to end
the operation
.
SHEET EXCHANGE
The plotter is waiting for the sheet to
be replaced during continuous copying
in the leaf sheet mode. Replace the leaf sheet (cut sheet) with
a new one, and resume continuous
copying.
F-ROM WRINTING
The plotter is now storing the tool
parameters and setting parameters.
The data is saved in flash memory so
that the saved data will not be erased
even when the power is turned off.
Do not turn the power off while this
message is displayed.
*TRANSMIT START*
It is in version-upgrade mode, since
key has been pressed when
turning the power on.
Turn the power off once and turn it on
again.
If the same message appears, contact
your distributor or a sales office of
MIMAKI.
SHEET END
REM/END
End of the sheet is detected while
detecting a mark or cutting roll sheet.
Cutting cannot be continued, since roll
sheet has ended.
Press the
key and replace it
with new sheet.
Sheet is lifted.
Fix the lifting of the sheet and press the
key to resume cutting.
The back of the plotter is exposed to
intense light.
Turn the plotter around not to be
exposed to the light, and press the
key to resume cutting.
ENTER/HOLD
REMOTE
REMOTE
END
REMOTE
END
REMOTE
REMOTE