MBO SVC 525C, Перевод оригинального руководства по эксплуатации, Страница: 158 / 171

154 Sheeter SVC 525C
Maintenance
Maintenance
Here's how to change the counter knives:
1) Remove venturi bar (3 or 12).
2) Loosen compressed air hoses.
3) Loosen counter holder screws (9) and turn positioning screws (8) away
from the counter knife.
4) Loosen the fastening screws (7) of the counter knife (2 or 11).
5) Remove the counter knife (2 or 11).
6) Clean stop edge (10) and check for damage.
7) Insert new counter knife until it lies against the stop edge (10).
8) Apply fastening screws (7) gently.
9) Apply positioning screws (8) gently.
10)Tighten fastening screws (7).
11)Counter the positioning screws (8) with the counter holder screws (9).
12)Install the venturi bar (3 or 12).
13)Reconnect the compressed air hoses.

The counter knife is changed.
9.4.4.3 Changing knives
Here's how to proceed to change the knife.
Prerequisites These prerequisites must be fulfilled:
• Main switch is switched off and secured.
• The electrotechnical regulations are heeded.
• Knife block is slid.
Under no circumstances should you turn the cutting cylinder while
changing knives; otherwise the swivel screws (11) and small metal
plates (10) will fall down.