MBO SVC 525C, Перевод оригинального руководства по эксплуатации, Страница: 125 / 171

Sheeter SVC 525C 121
Adjustment and operation
Adjusting the machine
8.4.14 Positioning the <Print mark> sensor
Here's how to proceed to adjust the <Print mark> sensor.
Prerequisites These prerequisites must be fulfilled:
• Web with print mark.
• The web is smoothed.
Positioning the
sensor
Here's how to position the sensor for the print mark:
1) Loosen the clamping lever (2).
2) Position the <Print mark> sensor (1).
The sensor has to be in the middle over the print mark (3).
3) Tighten the clamping lever again.

The <Print mark> sensor is set.
1 Sensor <Print mark>
2 Clamping lever
3 Print mark
Illustration 63: Position the <Print mark> sensor.
1
3
2
In order to get constant imprint precision, the print mark must be directed
as evenly as possible past the print mark sensor. Therefore, set the print
mark sensor directly over a guide plate.
If the print mark is cut off by the edge cut or the print mark is on the back
side of the printing, you have to set the print mark sensor on the round
bar of the longitudinal cut cassette and adjust it there to the print mark.
Use a counterholder if you set the print mark sensor on the round bar of
the longitudinal cut cassette.
Heed the changed sensor distance to the cutting cylinder unit.