MBO SVC 525C, Перевод оригинального руководства по эксплуатации, Страница: 127 / 171

Sheeter SVC 525C 123
Adjustment and operation
Adjusting the machine
8.4.16 Adjusting the format on the touchscreen
Here's how to proceed to adjust the format.
Prerequisites These prerequisites must be fulfilled:
• The warm-up phase of one hour has been observed.
• All sensors are adjusted.
Setting the format Here's how to set the format:
1) Go to the <Format setting> menu.
2) Press the <Number of sheets> input field and enter the required number
of sheets in the numeric input menu.
3) Press the <Number of chip-outs> input field and enter the required num-
ber of chip-outs in the numeric input menu.
4) The corresponding number of sheets and chip-outs will then be dis-
played graphically.
5) Press the corresponding input fields and enter the required lengths.
6) Press the <Inching> button.
The cutting cylinders carry out a reference run
7) Continue pressing the <Inching> button until 3 cutting cycles have been
carried out. (Required control path until the correct cutting position has
been reached).
8) Check the cut sheet and correct the cutting position as necessary.

The format is set.
CAUTION!
Operating the sheeter when it is cold.
Non-observance causes potentially serious damage to the cutting
units.
• Observe a warm-up phase of one hour.
• The sheeter knives should only ever be adjusted when heated.
• Only operate the sheeter when it is heated.
The maximum format length is 2032 mm.
It is composed of the number of sheets and the number of chip-outs.
You can enter a maximum of 6 s and 6 chip-outs per format.
(Due to the mechanical setting of the chip-out extraction, the length of
the individual chip-outs must be equal, however).
For a simple cut (without chip-out), only the upper cutting cylinder cuts.
If working with chip-out, the lower cutting cylinder cuts the rear edge of
the sheet in front and the upper cutting cylinder the front edge of the fol-
lowing sheet and thus the chip-out. Therefore, you have to adjust the
upper cutting cylinder for the chip-out.