Maytag MLE20PDAYW0, Руководство по обслуживанию

Страница: 134 / 204

4-78
Remove dryer drum (See page 4-68).
Two rear support rollers are mounted to the
rear bulkhead on shafts. Remove the tri-clip
from the shaft.
Slide support roller off the shaft.
There is another tri-clip behind the roller for
proper spacing. When replacing a roller,
always replace both tri-clips to make sure
roller will stay in position while running.
nOTe: Do not lubricate this wheel or shaft
because lubrication attracts lint and dust
which will cause premature wear of the
support bearing. Clean shaft with fine steel
wool to eliminate squeaks or replace worn
roller supports.
1.
2.
3.
4.
reMOve DruM rear
SuPPOrT rOllerS
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
Two rear support
rollers
Remove dryer drum (See page 4-68).
Remove the two rear support rollers
(See page 4-78).
Use an adjustable wrench between the rear
bulkhead and the back panel to remove the
9/16” nut on each shaft.
nOTe: To support the roller shaft while
trying to remove the 9/16” shaft a Vice Grip
needs to be used to hold the nipple on
the front of the roller shaft. Gripping the
shaft will damage the bearing surface and
cause noisy rollers and premature failure of
support rollers.
1.
2.
3.
reMOve rear SuPPOrT
rOller SHaFTS
9/16” Nut Behind
Rear Bulkhead
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
Proper
Grip Area