Maytag MLE20PDAYW0, Руководство по обслуживанию

Страница: 84 / 204

4-28
Lift clip on the front of the pump and slide
wires down to release them from the clip.
(See page 4-27, last photo).
Use a flat blade screwdriver to lift the right
edge of the rubber pad, on the right pump
support, out of the hole in the washer base.
Slide the pump to the right and then lift it
from the base of the washer.
nOTe: The 2 screws that secure the rubber
mounting piece to the bottom of the pump
support do not need to be removed to
remove the pump assembly.
Disconnect the pump-to-drain hose by
squeezing the ears of the clamp and pulling
the hose off.
nOTe: Take note of the notch on the hose
and the locating notch on the pump that it
aligns with.
nOTe: If squeeze clamp does not seem to
hold hose on the pump sufficiently, it can be
replaced with a standard worm gear clamp.
7.
8.
9.
10.
Disconnect the tub to pump hose by
squeezing the ears of the clamp and pulling
the hose off.
nOTe: When reinstalling the tub to pump
hose, align the arrow on the pump with the
tab on the hose.
Remove the pump from the washer.
nOTe: There may be water in the pump
motor housing. This is normal, the water is
used to cool the motor.
nOTe: The filter has a large keyed
shape on the top and a smaller shape on
the bottom, which fit into corresponding
sized shapes in the filter housing to
avoid improper filter orientation when it is
reinstalled.
11.
12.
Tab
Rubber Pad
Rubber Pad
Screwdriver
Tub To Pump Hose
Tab
Arrow
Pump to Drain Hose
Notch
On Hose
Notch On
Pump