Maytag MLE20PDAYW0, Руководство по обслуживанию

Страница: 162 / 204

5-18
Set the ohmmeter to the R X 1 scale.
Set digital ohmmeters to lowest scale.
Run winding test: Touch one ohmmeter test
lead to the bare motor wire connector, and
the other test lead to connector pin 5 (white-
orange wire). The meter should indicated
between 2.4 and 3.6Ω (run winding).
Start winding test: Touch one ohmmeter
test lead to the bare motor wire connector,
and the other test lead to connector pin 3
(violet wire). The meter should indicate
between 2.4 and 3.8Ω (start winding).
If either resistance is much larger than 4Ω,
replace the motor.
5.
6.
7.
8.
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
Drive MOTOr
The motor features a leadless motor
connection, comprised of a quick connector
wire harness which connects directly to the
motor. A motor test cord may be used to
electrically check operation of the various
electrical components without removing
them from the dryer. Testing in this manner
determines whether or not the part will
function independently of other electrical
components. In order to make an accurate
test, proper connection of the motor test Cord
is important.
Unplug dryer or disconnect power.
Turn off gas supply to dryer.
The connector has two locking tabs
securing the connector to the motor switch.
Press on both locking tabs to release the
connector from the motor switch.
With the wire harness removed, press
inward on the brown actuator disc in the
motor. The start and run winding can now
be checked for proper ohms.
1.
2.
3.
4.
Motor Connector
Pin 4
(Blue) To
Belt Switch
Pin 6
(Black - White)
Pin 1
(Red)
Pin 2
(Red)
Pin 5
(White-Orange)
Pin 3
(Violet)
Bare Motor Wire
Blue Wire
To Belt
Switch
Motor
Thermal
Overload