Maytag MLE20PDAYW0, Руководство по обслуживанию

Страница: 175 / 204

6-9
WaSHer Manual OvervieW TeST
Before replacing any system components,
perform this Manual Overview Test.
This cycle consists of 7 steps. In each step,
the washer will perform a Control Action
as described in the table below. Once the
action is completed, the washer will move to
the next step. Check Exit Condition column.
Each step can be differentiated from the
others by looking at the display indication.
To move to the next step before a control
action is complete, press any button except
the lower right (QUICK CYCLE) button.
When Step 7 is complete, the test runs
again starting at Step 1.
To exit the Manual Overview Test at any
time, press the lower right (QUICK CYCLE)
button.
The drain pump may be running in any of the
last 3 steps, depending on the water level
in the washer and position of the pressure
switch.
n
n
n
n
n
WOOLENS
PERM
KNITS
DELICATES
Exit
Step Display Condition
Control To be
Action Checked
1 On Door locks, drum
�
Door lock system
completion turns 1/2 revolution,
�
Child safety routine
only then door unlocks
and relocks.
2 & On Filling with both
�
Both Cold
key press cold inlet valves.
�
Inlet Valves
or if overfill
�
Overfill level
level is
detected
3 C On key Drum executes
�
Motor
press or reversing movement
�
Motor Control (MCU)
completion at wash speed
(10 min.).
4 On key Drain pump is on
�
Drain Pump
press or (4 min.).
completion
5 DELICATES On Drain pump is on
�
Drain Pump
completion (reach Level_sud
only plus 10 sec.).
6 & KNITS On key Drum rotates counter-
�
Motor
press or clockwise and ramps
�
Motor Control (MCU)
completion up to maximum speed.
7 On key press Stop motor to 0 rpm.
�
Motor
only after Door unlocks.
�
Motor Control (MCU)
rpm = 0 and
�
Door lock system
door is
unlocked
The drain pump may be running in any of the last 3 steps, depending
COLORS
PRESS