Page 70 P/N 03521015 Rev U1
Bio-Medical Devices Intl
17171 Daimler Street Irvine, CA 92614 800-443-3842 www.maxair-systems.com
Donning
1. Obtain a fully charged battery.
(Charger LED should be green
after battery is connected
to charger for more than 10
seconds.)
2. Assemble the Battery onto the Belt.
Place the top edge of the Belt under
the Battery Clip. Move the Belt fully
under and up to the top of the Clip.
Place the belt comfortably around the
waist with the battery near the side-
back of the right hip.
3. Remove a DLC from the DLC
dispensing box and attach the DLC
Lens, with the DLC cuff facing the
inside to the helmet. Remove the
DLC Protective film.
4. Connect the Helmet Power Cord
to the Battery. Push the Power
Cord Connector into the Battery
Receptacle until the Secure
Connection audibly clicks.
5. Loosen the ratchet adjustment knob
counter-clockwise to ensure the
Helmet will easily fit over the head.
6. Hold the Helmet by the rear
headband in one hand, pull the
front top edge of the DLC Cuff
down, and place your chin into the
DLC Cuff. Then, pull the Helmet
over and down on to your head.
WARNING
If there is any question about the disinfection status of the CAPR System due to a previous
use, it is recommended to disinfect it before using.
