Page 110 P/N 03521015 Rev U1
Bio-Medical Devices Intl
17171 Daimler Street Irvine, CA 92614 800-443-3842 www.maxair-systems.com
Assembly cont’d - SHROUD ONLY
5. Use the black pull tab to pull the Shroud up
over the Hard Hat front and back towards the
rear.
6. Continue pulling Shroud over and down
the back of the Hard Hat and snap to the
T-Tab Snap.
7. Attach one side-rear snap of the Shroud
to one side-rear snap on the Hard Hat,
then repeat for the other side. This step
completes the Shroud assembly.
Disassembly - Cuff and Shroud
Disassembly of the DLC Cuff is the reverse of Assembly steps 1-4, immediately preceding.
Disassembly of the Shroud is the reverse of Assembly steps 1-7, immediately preceding.
Assembly - ANSI Z87 Lens
1. Securely attach one set of side Lens
holes (2) over one side Hard Hat
Turn Clip and Mounting Post. Secure
Turn Clip vertically.
2. Securely attach the Lens center hole
over the Hard Hat center Turn Clip.
Secure Turn Clip vertically.
3. Securely attach other set of side Lens holes
(2) over other side Hard Hat Turn Clip and
Mounting Post. Secure Turn Clip vertically.
This step completes Lens Assembly.
Assembly - Face (DLC Cuff) or Headcover (DLC Shroud) to Assembled Hard Hat Helmet
2. Securely attach one set of side Lens holes (2)
over one side Hard Hat Turn Clip and Mount-
ing Post.
Secure Turn Clip vertically.
3. Securely attach the Lens center
hole over the Hard Hat center Turn
Clip.
Secure Turn Clip vertically.
4. Securely attach other set of side Lens holes
(2) over other side Hard Hat Turn Clip and
Mounting Post.
Secure Turn Clip vertically.
1. Remove Shroud/Cuff from packaging and lay on a clean surface with label facing up.
CAUTION
Before use, using the peel
tab, be sure to remove the
lens protecting film from the
DLC Cuff Lens.
DLC Shroud
(Disposable
Lens-Cuff
Shroud)
DLC Cuff
(Disposable
Lens-Cuff Cuff)
