Page 94 P/N 03521015 Rev U1
Bio-Medical Devices Intl
17171 Daimler Street Irvine, CA 92614 800-443-3842 www.maxair-systems.com
21.Continue pulling Hood inside-out
up and over Hood and HLF to
ensure contaminated outside is
folded up inside.
22. Continue pulling Hood off front
of Helmet releasing the Lens
from its Helmet attachment
points.
19. Untie both Neck and
Body Ties.
Either retie Neck ties
very loosely or cut them
off Hood to ensure Neck
Ties do not contaminate
Helmet, gown, or wearer.
Doff:
23. Discard Hood and HLF
per institutional protocol for
contaminated waste.
20.Grasp both Body Ties
and pull up to bring
back bottom of Hood
up and over Helmet.
24. Doff and
discard gown
per gown
supplier
protocol.
18. Ensure Hood Skirt is fully down on
all sides. Secure Neck ties to within
about 1/2 inch of neck. Secure body
ties around waist area.
16. Initiate donning of Heavy Loading
Filter (HLF) by tucking back bottom
up under back bottom of Helmet
17. Complete donning of HLF by pull-
ing down rear-to-front and securing
front bottom on Hood front velcro
strips (both sides in front).
27. Disconnect the Hel-
met Power Cord from
the Battery - push the
Secure Connection
Button down, pull Cord
Connector out, release
the Button. Connect the
Battery to the Charger.
26. Lift Helmet up and off
Head
25. Loosen Headband
by turning Ratchet
Know fully counter-
clockwise.
WARNING
Refer to Section 9, Instructions For Use: Charger, for details on
proper use of chargers and for charging batteries.