Page 84 P/N 03521015 Rev U1
Bio-Medical Devices Intl
17171 Daimler Street Irvine, CA 92614 800-443-3842 www.maxair-systems.com
Donning
`
9. Connect the Helmet Power Cord to the Battery.
Push the Power Cord Connector into the Battery
Receptacle until the Secure Connection audibly
clicks.
10. Loosen rear Ratchet Knob
(counterclockwise).
11. Hold Helmet in one
hand; pull Cuff down
with other hand, and
place chin into Cuff.
12. Pull Helmet over and
down onto head.
13. Secure Helmet by
tightening Ratchet
Knob as tight
as comfortably
possible, while
ensuring stability.
14. Pull back of Hood over, and
down behind Helmet.
15. Slide fingers between
face and Cuff on both
sides from chin to
temples to ensure
slight Cuff-to-face
tension*.
16. Ensure that the front
Headband is within
1/2 inch of eyebrows
for good visualization
of the Safety LEDs
17. Pull lower ties
around from
back and place
through tie slits in
hood bottom. Tie
securely.
18. Pull upper ties around and to
front and tie securely under
Lens. Ties should be within
about 1/2 inch from neck.
19. Suitable body
cover gown is
recommended. Tuck
Hood Shroud under
body cover gown for
optimum protection.
Doffing
Reverse steps 9 thru 19 to doff Helmet and remove Hood.
After disconnecting the Battery from the Helmet, connect
it to the Charger.
≤ 1/2
inch
(~1.25
cm)
WARNING
Refer to Section 9, Instructions For Use:
Charger, for details on proper use of chargers
and for charging batteries.