Page 28 P/N 03521015 Rev U1
Bio-Medical Devices Intl
17171 Daimler Street Irvine, CA 92614 800-443-3842 www.maxair-systems.com
Air Flow Switch Position
Low
Med
High
Air Flow in Liters Per Minute
190
215
240
9 Side Adjustment Straps with Snaps
- Height adjustment. Four holes represent four possible height adjustments
to accommodate different head sizes and ensure convenient viewing of the LED Safety Status Indicators. Secure into desired
position by snapping against post/stud. Both sides are to be in the same hole position.
10 Rear Liner Pads
- Provide cushion for comfort. Attached via adhesive. For replacement refer to Section 29,
Accessories.
11 Helmet Label
- PN, O.N. and SN identification. Refer to symbol definition chart for further details.
12 Rear snaps for Liner
- For mounting LIner to Helmet
13
.
TurnLock Power Cord Connector
- Easy and secure attachement and removal of Power Cord to/from Helmet.
14 Liner Power Cord Slot
- Allows removal and attachment of Liner without removaing Power Cord.
15 Airflow Controller
- Allows user to select range of air flow to me work activity and personal comfort.
CAUTION
The Air Flow Switch is user adjustable to match the amount of air flow with the user’s activity level and breathing
requirements.
NOTE
The flow levels, in liters per
minute, are only approximate.
NOTE
When the Helmet is initially connected to the Battery, all five LED Safety Status Indicators are lighted briefly indicating
all are functional. The red and yellow LEDs will turn off and the airflow increases to the appropriate operating level based on the
Air Flow Switch position. The green LEDs will be on as appropriate to the battery charge level as indicated in the LED Safety
Status Indicators table (previous page).
CAPR Helmets are equipped with a switch which adjusts the operating airflow. When the Helmet is first turned on it will start at a
low level, then the airflow will increase to a preset point according to the switch position.
16 Comfort Pad
-
Provides cushion for comfort and sizing for very small head sizes. Attached via Hook and Loop,
and removable. For replacement, refer to Section 29.
17 Power Cord
- Battery to Helmet Connection. For replacement, refer to Section 24, Helmets and Helmet Accessories.
18 Headband Ratchet Knob
- Head circumference adjustment knob