Page 64 P/N 03521015 Rev U1
Bio-Medical Devices Intl
17171 Daimler Street Irvine, CA 92614 800-443-3842 www.maxair-systems.com
CAUTION
Prior to assembly, visually inspect the perimeter of the Helmet and verify the white edges
are tucked inside the clear edges. If not, manually tuck the Helmet outer shell white
edges under and inside of the Helmet inner shell clear lip - all around the Helmet.
WARNING
Never mount a FCC on a Helmet until a fully functional Filter Cartridge is securely in place on the Helmet.
17. Filter Cover Cap (FCC)
T-Tab
The Filter Cover Cap, 2061-08 (01031284) provides protection for MAXAIR Filter Cartridges in various Cuff and Shroud
configurations.
Asssembly
2. Hold the FCC in one hand and insert the
front Adapter of the Helmet/Liner/Filter
Cartridge into the inside of the FCC Front
Adapter, and pull the FCC back, over, and
down onto the Helmet.
3. Pull the FCC fully down on the
Helmet (Squeeze together) to
align the FCC T-Tab hole (A)
over the Helmet rear Bottom
Snap (B).
4. Ensure that the T-Tab is fully snapped down on the Helmet rear
Bottom Snap (use thumb if necessary to press in place).
1. Align the Helmet Front Adapter to
the indentation on the inside of the
FCC Front Adapter.
A
B
5. Ensure that each FCC Side Adapter (A) is snapped fully down over each Helmet
Side Adapter (B).
A
B