Page 76 P/N 03521015 Rev U1
Bio-Medical Devices Intl
17171 Daimler Street Irvine, CA 92614 800-443-3842 www.maxair-systems.com
Donning
2. Connect Helmet Power
Cord to Battery; push Power
Cord Connector into the
Battery Receptacle until the
Secure Connection audibly
clicks.
3. Loosen headband
Ratchet Knob
(counterclockwise).
4. Pull top of DLC Cuff
down to insert chin
while pulling Helmet
over and down on
head.
5. Tighten Ratchet Knob
secure as comfortably
possible, while
ensuring stability.
7. Pull back of shroud up and over the
Helmet. Slide fingers between face and
cuff on both sides from chin to temples
to ensure slight Cuff-to-Face tension.
6. Position front headband within ½ inch
of eyebrows for visualization of the
Safety LEDs.
WARNING
After donning, if conditions 1 and 2 both are not achieved, switch to
the other size DLC and repeat the Assembly and Donning steps to this
point.
Condition 1:
Ensure the DLC Flappers
are away from the Lens, positioned
perpendicular to your temples, and in
front of the FCC Side Tabs.v
Condition 2:
Ensure slight tension on the
cuff is felt continuously while sliding the
index or first finger between the cuff and the
face all along the chin and up to the temples,
from the right side of the face to the left.
1. Assemble the Battery onto the Belt -
Place top edge of Belt under Battery
Clip; move Belt fully under and up to
top of Clip. Then Don by placing belt
comfortably around waist with battery
near the side-back of the right hip.
DLC Flappers
FCC Side Tabs
≤ 1/2
Inch
(~1.25 cm)
