Maretron DSM410, Руководство пользователя

Страница: 168 / 289

DSM410
User’s Manual
Page 152 Revision 1.7.2
Figure 155
– RAA100 Custom Rudder Calibration Confirmation Screen
6.20.3.2 Set to American Standard (240-33 ohm)
Use the option for rudders using a rudder angle sender with the standard American resistance range
(240 ohms at full port 45°, 33 ohms at full starboard 45°).
6.20.3.3 Set to European Standard (0-180 ohm)
Use this option for rudders using a rudder angle sender with the standard European resistance range
(0 ohms at full port 45°, 180 ohms at full starboard 45°).
6.20.4 Rudder Number
First, the rudder number must be configured. For a vessel with a single rudder, the number should be
set to “0”. For a vessel with two rudders, the port rudder should be set to “0” and the starboard rudder
should be set to “1”. Each rudder must have a rudder number that is different from all other rudders. A
screenshot of rudder number configuration is shown in Figure 156 below.
In order to configure the rudder number, use the Scroll Up (
) or Scroll Down ( ) keys to move
the highlighted cursor to “Rudder Number:”, then press the Enter key (
) to move the cursor over to
the rudder number value. Use the Scroll Up ( ) or Scroll Down ( ) keys to select the desired
rudder number. Finally, press the Enter key ( ) to confirm your selection and store the new rudder
number within the RAA100.