Maretron DSM410, Руководство пользователя

Страница: 146 / 289

DSM410
User’s Manual
Page 130 Revision 1.7.2
6.16 Maretron GPS200 Configuration
This describes the configuration of the Maretron GPS200 firmware version 3.5.0. The GPS200 has
several different programmable parameters that are configurable by the DSM410 display. Normally, it
is not necessary to configure the GPS200 although there may be some circumstances where
configuration is desirable. The following sections describe the different configuration modes including
the “Restore Factory Defaults” configuration, which allows you to return the GPS200 to the factory
settings.
Figure 124
– GPS200 Configuration Screen
6.16.1 Advanced Configuration
Advanced Configuration changes some complex parameters within the device, and should only be
performed by an advanced user. Typically advanced configuration is only done at installation and
should not need to be done while at sea. The Advanced Configuration Screen is shown below.
Figure 125
– GPS200 Advanced Configuration Screen
6.16.1.1 Device Instance
The Device Instance will be used to identify the GPS200 device on the network. Unless there are
multiple GPSs on the network, this should be left at zero.