DSM410
User’s Manual
Page 138
Revision 1.7.2
6.17.6
IP Address
This parameter is the IP (Internet Protocol) address used by the IPG100. You will need to specify this
address to N2KView
®
clients in order to allow them to connect to the IPG100. If the “DHCP”
parameter is set to “Yes”, you do not need to configure this parameter. If the “DHCP” parameter is set
to “No”, you will need to configure this parameter.
6.17.7
Subnet Mask
This is a mask used to divide an IP Address into subnets. Basically, it tells the computer how much of
the IP Address defines the network, and how much may be used by computers on the network. For
most networks, the first three parts of the IP address define the network (i.e., every computer on the
network must have the same values), and the last part defines the computer (i.e., every computer on
the network must have a different value). Where the value 255 appears in the subnet mask, the
values define the network and must be the same.
The most common value is 255.255.255.0.
If the “DHCP” parameter is set to “Yes”, you do not need to configure this parameter. If the “DHCP”
parameter is set to “No”, you will need to configure this parameter.
6.17.8
Default Gateway
This is the IP address of the router.
If the “DHCP” parameter is set to “Yes”, you do not need to
configure this parameter. If the “DHCP” parameter is set to “No”, you will need to configure this
parameter.
6.17.9
Default DNS
This is the IP address of a computer on the Internet that can identify and locate computer systems
and resources on the internet. In most cases, this should not be required by the IPG100 and may be
left blank.
If the “DHCP” parameter is set to “No”, you will need to configure this parameter.
6.18 Maretron J2K100 Configuration
This describes the configuration of the Maretron J2K100 firmware version 1.0.13.2. The DSM410 is
capable of configuring settings for the J1939 to NMEA 2000® Gateway (J2K100). A screenshot of the
J2K100 configuration menu is shown in Figure 135 below.
Содержание DSM410
Страница 103: ...Revision 1 7 2 Page 87 Figure 75 DSM150 DSM250 DSM410 Remote Device Selection...
Страница 171: ...Revision 1 7 2 Page 155 Figure 159 RAA100 Setting the to Sender Gauge Resistance...
Страница 228: ...DSM410 User s Manual Page 212 Revision 1 7 2 Figure 244 Compass Rose North Up Display...
Страница 248: ...DSM410 User s Manual Page 232 Revision 1 7 2 Figure 274 Favorite Screen Showing Highlighted Switch Breaker...