M&R Challenger II 12 COLOR, Руководство пользователя

Страница: 75 / 176

PREVENTIVE MAINTENANCE PROCEDURE
CHALLENGER Series II Bulletin No. PH7
Maintenance Point
(AC Print Stations Only)
Frequency Interval
Procedure Information
Check and adjust as required, the print carriage timing belt tension on each of the print stations.
Every Six Months
Tools required: 1 - 1/8” Allen wrench
1 - 3/16” Allen wrench
67
The frequency of the following preventive maintenance procedure is
based on a 8 hour daily production shift or 40 hour work week.
CAUTION!
To prevent possible injury
to personnel and/or damage to the
equipment, lock out and tag the electri-
cal service and compressed air supply
to this equipment. Refer to pages 55
and 56 of this manual for information
regarding lock out/tag out procedures.
CAUTION!
3. Adjust the 1/4”-20 X 1-1/4” allen head cap screw in a
clockwise direction to increase the tension on the timing belt.
Generally, this will only be a slight adjustment, perhaps 1/4
to 1/2 turn of the screw. (See illustration at right)
1. Using a 1/8” allen wrench, remove both the left and right
dust covers by loosening the three 10-24 X 3/8” button head
allen screws.
2. Using a 3/16” allen wrench, loosen the two 5/16”-18 X
3/4” button head allen screws on the tension bracket assem-
bly. (See illustration at right)
4. Re-tighten the 5/16”-18 X 3/4” button head allen screws.
5. Re-install both the right and left dust covers using the 10-
24 X 3/8” button head allen screws.