M&R Challenger II 12 COLOR, Руководство пользователя

Страница: 59 / 176

51
PREVENTIVE MAINTENANCE PROCEDURE
CHALLENGER Series II Bulletin No. IX1
Maintenance Point
Frequency Interval
Procedure Information
Check moisture trap and drain as needed. In normal operation, you should never notice any accumulation of water in
the moisture trap. If water is discovered, you should inspect the air compressor receiver tank and air refrigeration unit
for proper operation. Clean, filtered regulated air only must be supplied to the equipment.
Daily
Tools Required:
None required
The frequency of the following preventive maintenance procedure is
based on a 8 hour daily production shift or 40 hour work week.
1. Remove moisture trap reservoir by pushing up while turn-
ing the reservoir bowl 1/4 turn to the left, then pull straight
down. Inspect the inside of the reservoir for indications of
standing water or excessive moisture. If water or excessive
moisture is discovered in the reservoir, clean water/moisture
from reservoir and inspect the compressed air supply lines to
the equipment. Also inspect the refrigerated air line chiller
and air compressor for proper operation. If water and mois-
ture are not detected in the reservoir, replace the moisture
trap reservoir by reversing removal procedure described
above. Reservoir should lock and “seat” when properly
installed. (Refer to the illustration at the right)
CAUTION!
To prevent possible injury
to personnel and/or damage to the
equipment, lock out and tag the electri-
cal service and compressed air supply
to this equipment. Refer to pages 55
and 56 of this manual for information
regarding lock out/tag out procedures.
CAUTION!