M&R Challenger II 12 COLOR, Руководство пользователя

Страница: 39 / 176

Challenger II
mrprint.com
May 2005
M&R Printing Equipment, Inc. - Glen Ellyn, Illinois 31
E 300 Operator Interface
Press the "ARROW DOWN" key one time, then press the
"ARROW RIGHT" key one time to access the "Enter
Program" menu item. This control function is used to enter
print sequences for the Revolver program mode of opera-
tion. When the flashing cursor is located under the letter "E"
in the word "ENTER", press the "ENTER" key one time. You
will see the "WAIT" message appear in the message win-
dow, after which your pre-selected program information will
be saved in the PLC memory.
The next menu item is "Revolution No." Press the "ARROW
DOWN" key one time, then press the "ARROW RIGHT" key
one time. This control function allows the selection of up to
10 different revolutions to be programmed for print, flash
operation in the Revolver program. Enter a number from 1 to
10, then set the active heads to either "Single" or
"Double/Multi" (remember, flashes units must be pro-
grammed before you enter the "Revolver" screen), then
press the "ENTER" key one time. Your "Revolver" program
will be displayed on the screen. "1" indicates a print station
is printing in "Single" mode. "2-9" indicates the print station
is printing in "Double/Multi" mode. "F" indicates that the
print station is operating in the "Flash" mode.
The "Pallet No." indication provides a visual indication of
how many pallets are entered in the program sequence for
each revolution of the indexer. The numerical indication will
change (count down) as the press continues through its
operation.
The next menu item is "Job No.". "Job No." is used to enter
a job number from 1 to 3 which is saved in the PLC memo-
ry. Simply press the numeric key from 1 to 3, then press the
"ENTER" key. (See illustration Figure 10 at the right)
The next menu item is "Job Clear". This menu item is used
to clear all currently active Revolver program data from the
PLC. To use it, press the "ARROW DOWN" key once, then
press the "ARROW RIGHT" key one time. Now press the
"ENTER" key. The indication will toggle from "ON" to "OFF".
When the indication reads "ON", then all Revolver program
data as entered by the Operator will be cleared from the
PLC memory.
The next menu item is "Alarm Enabled". This menu item pro-
vides the system Operator with a way to either enable or
disable the audible alarm signal which sounds just before
the completion of a programmed print sequence. To turn the
alarm signal "OFF", press the "ENTER" key when the flash-
ing cursor is located under the letter "O" in the "ON" indica-
tion. To turn the alarm back "ON", press the "ENTER" key
once again, and the alarm will turn back on. Press the
"PREV" button to return to the previous screen.
Figure 10