35
Using Remote Surveillance
PTZ
The PTZ tab allows you to configure the
settings for connected PTZ cameras (not
included).
NOTE:
Please refer to the instruction manual of
your PTZ camera for complete details on
configuring your camera settings.
To open PTZ setup:
• Click
SETUP
at the top of the main screen
and then click
PTZ
Configure PTZ settings for each channel with a
connected PTZ camera (not included):
NOTE:
Click
NEXT/PREVIOUS
for additional
channels (8-channel models only).
•
PROTOCOL
: Select
PELCO-D
or
PELCO-P
•
ADDRESS
: Select from
1~255
•
BAUD RATE
: Select
1200
,
2400
,
4800
, or
9600
•
DATA BIT
: Select
5
,
6
,
7
, or
8
•
STOP BIT
: Select
1
or
2
•
VERIFY
: Select
ODD
,
EVEN
,
MARK
,
SPACE
, or
NONE
Click
APPLY
to save your settings and then
click
OK
in the confirmation window.
NETWORK
The Network tab allows you to configure your
IP and DDNS settings.
To open Network setup:
• Click
SETUP
at the top of the main screen
and then click
NETWORK
To configure IP settings:
1. Under TYPE, select
DHCP
(default),
PPPoE
, or
STATIC
. If DHCP, go to
step 5
. If
PPPoE, go to
step 2
. If STATIC, go to
step 3
.
NOTE:
DHCP allows you to quickly connect to
your network by obtaining an IP address from
the router. After the initial setup, we recommend
that you disable DHCP and set the IP address
between 1~100. For example, if your IP address
is 192.168.0.107, change the last digits to 90 (i.e.
192.163.0.90). This ensures that port forwarding
will not change in the event of power failure or
resetting of your network.
2. If you select
PPPoE
in step 1, enter your
PPPoE user name
and
password
in the
respective fields.
Figure 29.0 PTZ menu
Figure 30.0 Network menu
Figure 30.1 PPPoE setup