LINK ELECTRIC & SAFETY CONTROL COMPANY OmniLink 5000, Руководство по эксплуатации

Страница: 52 / 80

April 17, 2000 Man ual Versio n 1.0
6.5
Min Position Reached The slide has gone as low as the min position programmed in the
configuration menu and will not be allowed to go lower.
Moving Up The slide is moving up.
Moving Down The slide is moving down.
System Off The slide adjust system is turned off. The slide can still be manually moved
by using the jog up and jog down buttons. The slide position will still be
shown if the position transducer is still functioning correctly.
Waiting for Cntr-Bal
The slide adjust system is waiting for the counterbalance, if present, to come
to its correct pressure before automatically moving the slide.
Slide Too High The slide is higher than the slide setpoint plus tolerance.
Slide Too Low The slide is lower than the slide setpoint minus tolerance.
Hyd Overload Tripped The hydraulic overload has tripped. The slide will not move down in this
condition.
Auto-Adjusting
The slide is automatically going to the programmed slide setpoint.
Waiting for Top The slide must be at the top of the stroke for automatic positioning to occur.
If a job is recalled at the bottom of the stroke, this message will be displayed
until the press is at the top.
E-Stop Button Emergency stop button is depressed. The slide will not automatically move in
this condition.
Waiting S/A Switch Waiting for the slide adjust switch to be turned on. The slide cannot move
while the slide adjust switch is in the off position.
LMC is Out The Link Master Control relay is disengaged for some reason (possibly an
error at the control). No slide movement may be made while the LMC is
tripped.