6. Software Control – Lightware Device Controller Software
MX-FR Series Modular Matrix Frames – User's Manual
82
Applied CPU2 firmware: v3.5.7b8 | LDC software: v2.5.17b2
6.5.3.7.
DVI-I Type Input Port
Supported Boards:
▪
MX-DVII-HDCP-IB
▪
MXD-UMX-IB
Video Source
The signal type of the connected source can be selected from the drop down list: Analog RGB, Analog YUV,
Analog Auto, Digital, or Auto source. The Auto source setting accepts both digital and analog signals on the
input and selects the one which is first detected.
Audio Source (refers to the MXD-UMX-IB board only)
The signal that is sent to the matrix crosspoint can have embedded audio.
▪
No Audio:
Disable the audio of the signal.
▪
HDMI Audio:
Leave the incoming signal as it is.
▪
Audio Addon:
Use the analog stereo or S/PDIF audio input and embed it into the HDMI signal.
Output Format
The output signal type can be selected (DVI or HDMI mode) that is sent towards the matrix crosspoint.
▪
Pass HDMI:
Sending HDMI signal to the crosspoint only if the incoming signal is HDMI or the audio
settings are set to embed audio.
▪
Force DVI:
Sending only DVI signal to the crosspoint without embedded audio.
▪
Automatic:
Detecting the output board types in the matrix frame and setting the signal type accordingly.
If there are only HDMI compatible output boards, then the signal type will be HDMI. If there is one or
more DVI output boards in the matrix frame, then the signal type will be DVI. (Note that DVI-HDCP
boards are HDMI compliant.)
Analog Video Options
Analog video signals are digitized on the
input. The input port measures the incoming
analog signal and determines timings. If the
parameters need adjustment, it can be done
on the right side at Analog options. In this
case, the Timing ID field changes to User
modified until the parameters are saved.
The timing parameters can be adjusted
if needed, and the timing presets can be
saved for each resolution separately.
ATTENTION!
The automatic signal format detection requires the incoming signal be in line with the EDID
set on the input, which requires proper cabling. Always use high-quality cables for connecting sources: a
VGA cable where all the pins are wired (DDC channel) with the supplied VGA-DVI-A converter or a direct
VGA-DVI cable is highly recommended.
#audio
#analogaudio
RCA
Switch
S/PDIF
in
out
Analog audio
A/D converter
D/A converter
Switch
Balanced
in/out
HDMI
RGBHV / YUV
DVI / HDMI
S/PDIF out
S/PDIF in
DVI-I
De-embedder
Embedder
A/D converter
S/PDIF
crosspoint
DVI-I Type Input Port Properties (MXD-UMX-IB)
