Lightware MX-FR17, Руководство пользователя

Страница: 43 / 190

4. Operation MX-FR Series Modular Matrix Frames – User's Manual 43
Applied CPU2 firmware: v3.5.7b8 | LDC software: v2.5.17b2
Step 3.
Press and release the
Take
button to execute switching. Now the selected input is switched to the
selected output(s).
ATTENTION! A source button can be pressed twice to preselect all outputs. Outputs that are connected to
the pressed input light up and all other outputs start to blink. Some outputs can be unselected if needed,
and then pressing
Take
executes the switching.
INFO:
Test input
and
Preview output
ports can be accessed with
up

and
down

buttons when the LCD
shows their status. An asterisk on the LCD indicates if the port is selected just like the back light for other
I/O ports.
INFO: If the pressed destination is locked, then it could not be selected. This is indicated by a short flash
of the
Output lock
when a locked destination is pressed.
Disconnecting or Muting in Take Mode
Step 1.
Press and release the selected
source
button.
The pressed source button and all destination buttons that are currently connected to this source
will light up.
Step 2.
Press and release the desired
destination
button shines green. The pressed destination or multiple
destination(s) will turn dark.
Step 3.
Press and release the
Take
button to execute disconnection.
INFO: Deselected destinations are disconnected from any source, thus output devices will display a black
image, a
no signal
message, or will turn off automatically.
#mute
Creating a Connection in Autotake Mode
Step 1.
Press and release the desired
destination
button.
The pressed destination button and the currently connected source button light up green. If no
source is connected (the output is muted) no source button will light up.
Step 2.
Press and release the desired
source
button.
Switching is executed immediately. Switching between sources to the selected destination can be
done directly.
INFO: The ‘Switch In## Out##’ menu activates automatically when entering
Autotake
mode to give quick
access to the Test input and Preview output ports.
INFO:
Test input
and
Preview output
ports can be accessed with
up

and
down

buttons when the LCD
shows their status. An asterisk on the LCD indicates if the port is selected just like the back light for other
I/O ports.
Disconnecting or Muting in AUTOTAKE Mode
To prevent accidental muting, this action is inhibited (disabled) in
Autotake
mode. Pressing a
source
button
twice would cause accidental disconnecting.
   