2. Installation
MX-FR Series Modular Matrix Frames – User's Manual
15
Applied CPU2 firmware: v3.5.7b8 | LDC software: v2.5.17b2
Step 5.
Gently push the board in until it stops, then press the plate at the indicated places at once. Thus, the
connector of the board and the motherboard will be put together.
Step 6.
Tighten the two screws by hand and fix them by a screwdriver with PZ1 head.
INFO:
The mute-, lock-, and crosspoint states are stored in the matrix, all other I/O board-related settings
are stored by the I/O board series. (An I/O board and its variants with Audio add-on mean the I/O board
series.) E.g. if an MX-TPS-IB had been installed previously in a matrix and an MX-TPS-IB-A board was
installed later, the previous settings would be applied to the board.
CPU
8CH OUTPUT BOARD
FOR HDMI WITH 3D
AND
ANALOG
AUDIO
MX-HDMI-3D-OB-A
OUT
1
OUT
2
OUT
3
OUT
4
OUT
5
OUT
6
OUT
7
OUT
8
2.4. PSU Installation and Handling
MX-FR80R and MX-FR65R Frames
The PSU of these frames is hot-swappable, thus you do not have to switch off the matrix to replace or install
a PSU.
Three slots are available for the FNP-850-12RG PSUs. The load depend on the installed I/O boards, so the
best practice for a PSU replacement is to have two PSUs in use continuously. Thus, the third PSU can be
replaced safely:
Step 1.
Unplug the
power cord
from the AC socket, then from the desired PSU.
Step 2.
Loosen the
fixing screw
of the PSU by hand and/or a flat-head screwdriver.
#power
#redundancy
