Lenze 9300 vector Series, Системное руководство

Страница: 42 / 232

Configuration
Use of funktion blocks
2−34
l
EDSVF9383V−EXT EN 2.0
Configuration code
Configures the input with a signal source (e. g. terminal signal, control code, FB output, ...). Inputs
with the same code are distinguished by their subcode. The subcode is added to the code (Cxxx/1).
These codes are configured via the subcode.
Every input can only be connected to one signal source.
Display code
Indicates the current input value. Inputs with the same code are distinguished by their subcode. The
subcode is added to the code (Cxxxx/1). These codes are displayed via the subcode.
Display codes cannot be edited.
Function
Shows the mathematical function as a block diagram (see Fig. 2−15).
Parameterisation code
Adapts the function and the behaviour to the drive task. The possible settings are described in the
text and/or in line charts. (
¶
2−41)
Output symbol
Indicates the signal type. Connections with inputs of the same signal type are possible. (
¶
2−32)
Every output is defined via a selection number. The selection numbers are listed in selection lists
(1 ... 4) corresponding to the different signal types.
The selection numbers are used to connect the outputs with inputs.
Example:
(FCNT1, see Fig. 2−15)
l FCNT1−OUT
¢
selection number 6400 (analog signal, selection list 1).
l
FCNT1−EQUAL
¢
selection number 6400 (digital signal, selection list 2).
)
Note!
You can only configure outputs which are led out of the FB.
Output name
Consists of the FB name and a designation. Outputs with the same function are distinguished by a
number following the designation.