Lenovo ThinkServer TD340, Руководство по установке операционной системы

Страница: 45 / 82

e. In the Allowable Drives window, select the hard disk drive on which you want to install the
operating system.
f. Type the amount of space (in MB) of the new partition and then click OK .
• Manually create a swap partition
To create a swap partition, do the following:
a. Click Create . The Create Storage window is displayed.
b. Select Standard Partition and then click Create .
c. In the Add Partition window, select swap from the File System Type drop-down list box.
d. In the Allowable Drives window, select the hard disk drive on which you want to install the
operating system.
e. Type the amount of space (in MB) of the new partition and then click OK .
13. If the Format Warnings window is displayed, click Format to format the hard disk drive.
14. In the “Writing storage configuration to disk” window, click Write changes to disk .
15. In the “Boot loader operating system list” window, click Next .
16. The default installation is a basic server installation. You can customize your server by selecting a
different set of software from the software list or adding additional repositories that you want to use
for the software installation. Select
Customize now or Customize later . Then, click Next . The
installation process begins.
Notes:
• If you select Customize now , you can select software installation packages of your choice. Then,
click Next .
• When installing the operating system in UEFI mode, do not select the package named
tboot-1.7.4-1.el6.x86_64 - Perfomrms a verified launch using Intel TXT .
• If a warning message is displayed, configure the settings. The following steps are based on the
scenario that Continue is selected in this step.
17. After the installation is completed, click Reboot to restart your server.
18. The installation continues after the server restarts. In the Welcome window, click Forward .
19. Click Yes, I agree to the License Agreement and then click Forward .
20. In the Set Up Software Updates window, configure the settings, and then click Forward .
21. In the Finish Updates Setup window, click Forward .
22. Set your user name and password and then click Forward .
23. Set your time and date and then click Forward .
24. In the Kdump window, select Enable kdump if you want to enable kdump, and then click Finish
to complete the installation.
Note: When prompted to restart the server, click Yes ➙ OK .
25. Follow the instructions on the screen to log in to the operating system.
Installing drivers for the Red Hat Enterprise Linux AS 6.5 (x64) operating
system
Note: The drivers for the Ethernet card, HBA card, and CNA card are installed during the operating system
installation.
To install the driver for an onboard graphics card, do the following:
Chapter 2
.
Installing an operating system in legacy mode
39