6600-NG User’s Manual
125-9110A
Page 56
Figure 3.33 : Modify Limits (password)
The password has been provided on the calibration certificate. Enter the password digits followed by
ENTER
. The screen will appear as shown below.
Figure 3.34 : Modify Limits (selection)
To modify a specific limit value, press the number-key for that limit. If ‘
1
’ is pressed to modify the ‘Max
knots’ limit, the screen will appear as below. The last line of the display will show the upper and lower
bound of the value that may be entered. Other limit values can be modified similarly.
Figure 3.35 : Modify Limits (value entry)
An explanation of each limit follows.
1)
Max knots:
This limit can be set between 100 and 690 knots. It defines the maximum
airspeed that can be controlled. It also defines the maximum differential pressure (Qc) that can
be controlled. The factory setting is 400 knots.
2)
Min knots:
This limit can be set between -50 and -500 knots. It defines the negative-airspeed
limit. It also defines the most negative differential pressure (Qc) that can be controlled. The
factory setting is -50 knots.
Modify Limits
1) Max knots:
5) Max feet:
52000
2) Min knots: -50.0
6) Min feet:
-2000
3) Max knots/m: 250.0
7) Max feet/m:
3000
4) Max Mach: 1.000
8) Max Dfin:
30
Enter a value between 100.0 and 690.0
CLR
for limit selection
Modify Limits
1)
Max knots: 400.0
5)
Max feet:
52000
2)
Min knots: -50.0
6)
Min feet:
-2000
3)
Max knots/m: 250.0
7)
Max feet/m:
3000
4)
Max Mach: 1.000
8)
Max Dfin:
30
Press
CANC
to exit
Modify Limits
Please enter password:
Press
CANC
to exit
