95
11
Network Configuration
Network configuration is required if your NVR operates in a
network shared by other devices.
NOTE!
The default IP address is 192.168.1.30 for NIC 1 and 192.168.2.30
for NIC 2.
Basic Configuration
TCP/IP
1.
Click
Network > Basic
.
2.
Set the network parameters as needed. DHCP is enabled by
default.
You can choose a working mode if the NVR has two NICs:
Multi-address mode
: The two NICs work independently
and can be configured separately. Either NIC can be
chosen as the default route; data will be forwarded
through this NIC when the NVR connects to the
extranet.
Load balance mode
: The two NICs are bound to the
same IP address and work together to share network
traffic.
Net fault-tolerance mode
: The two NICs are bound to
the same IP address. In cases where one NIC fails, the
other takes over service seamlessly from the faulty one
to ensure network connectivity.
Содержание NVR-NDAA-POE-4CH
Страница 18: ...18 2 Change the password into a strong one then click OK 3 Set the unlock pattern...
Страница 94: ...94 3 Click Backup to export the counting statistics to a storage device...
Страница 146: ...146 5 Configuration Click Setup on the top and then click the menus on the left to configure parameters...