100
NOTE!
Automatic mapping (Auto) is recommended. Ports will
conflict if not configured properly.
For an NVR with multiple NICs, port mapping should be
configured based on the NIC specified as the default route.
3.
Click
Refresh
and check that
Active
is displayed for these
ports under
UPnP Status.
4.
Click
Apply
to save the settings.
Manual Port Mapping
If your router does not support UPnP, configure the internal and
external ports manually.
NOTE!
The principle of port mapping is that the internal and
external ports of the NVR are consistent with that of the
router.
Some routers may require the same internal and external
ports for the NVR and the router.
1.
Click
Network > Basic.
2.
Select
Manual
for
Mapping Mode
, and then set external
ports manually.
Содержание NVR-NDAA-POE-4CH
Страница 18: ...18 2 Change the password into a strong one then click OK 3 Set the unlock pattern...
Страница 94: ...94 3 Click Backup to export the counting statistics to a storage device...
Страница 146: ...146 5 Configuration Click Setup on the top and then click the menus on the left to configure parameters...